There is genuinely only one good reason to install a Fire Valve in your house if you heat with a furnace that burns either fuel oil or liquefied petroleum gas and that is to be safe. If you think about it furnaces are a blend of electrical and mechanical units developed to develop a fire that is very carefully managed to heat your home to the heat you want Even with how cold it gets outside. If any one of the many components fails it could possibly mean that the fire could escape the confines of the furnace leading to damage to your house. This might also mean that any people in the house could become victims of the fire resulting in either damage from burns or smoke inhalation. It might even, in the worst case scenario, result in death. Nevertheless, the good news is that steps can be taken to lessen the possibilities that this might occur
There are number things one can do to minimize this type of risk. An important one of these is to install a Fire Valve. The Fire Valve and the associated things needed to install appropriately are not terribly expensive and the serenity of mind you will get from knowing that you have made your house a less dangerous place is well worth the cost.
Here are the basics about how the Fire Valve works. no matter if your furnace burns fuel oil or liquified petroleum gas it should work within a certain fairly specific temps vary. If a problem within the furnace grows it will usually either shut down completely or refuse to shut down when it should. If it fails to turn off it will begin to get hotter than it is supposed to get. If you haven’t installed a Fire Valve this turn into a problem. If you have one a temperature sensor is triggered. These sensors are made to go off at a variety of different temperaturess to be relevant to differing types of furnaces. Generally these sensors trigger at 66 to 72 degrees celsius (approximately 155 degrees f) for most applications but also come configured to set off at a slightly higher rate for other higher temperature applications
This sensor is mounted inside the insulating casing of your boiler. It is connected by a capillary tube, just a thin tube, to a remotely functiond valve. This valve is installed in the fuel line that supplies No matter which certain type of fuel your furnace is designed to burn between the tank and the furnace. The capillary tube contains a liquid. If the heat of your furnace goes above the level expected for that furnace the liquid in the capillary tube expands. This causes the valve to shut which in turn closes off the fuel supply to the furnace. Your furnace will of course shut off but that is a Minor inconvenience compared to what might happen if you hadn’t installed a Fire Valve.
Once you have made the proper choice, to have a Fire Valve installed please make sure to have the work done by a qualified professional. Though some homeowners may have the necessary equipment and knowledge to effectively install this safety machine most people should at all times rely on the specialists for a job like this.
